-
₹799.00 (Inc. GST)
Akko x MonsGeek acrylic 16-key switch tester. We selected a wide range of different switches from 3 different brands for users to test at minimal cost. Be aware! Some switches may come in different versions in different batches. [Linear Switches] Akko CS Wine Red Akko CS Matcha Green Akko V3 Cream Yellow Akko CS Crystal…
-
₹500.00 (Inc. GST)
- Special edition Keycap Pullers from FILCO based on the FKP01
- Designs based on desserts and drinks popular in Japan
-
₹10.00 (Inc. GST)
Hotswap sockets for Cherry MX-compatible switches, by Gateron. Works for up to 50,000 cycles. NB: Gateron hotswap sockets must be used with PCBs specifically designed for hotswap sockets from Gateron or any other compatible brand like Kailh or TTC.
-
₹20.00 (Inc. GST)
You can use this jar to store or mix lubricants for your next session of keyswitch lubing. This is the same jar we ship our Krytox greases in.
-
₹360.00 (Inc. GST)
A simple switch puller that does the job. It pulls your switches out of their hotswap sockets and lets you change them with relative ease.
-
₹500.00 (Inc. GST)
Wuque Fr4 Ruler designed for the community’s style.
-
₹360.00 (Inc. GST)
The Filco KeyPuller is used to remove keycaps from mechanical and membrane keyboards.
Not meant to be used with laptop or pantograph key mechanisms!
-
₹10.00 (Inc. GST)
The very best hotswap sockets for hotswap PCB designs, now made even better with increased durability!
-
₹1,595.00 – ₹5,000.00 (Inc. GST)
All-aluminum switch openers from Wuque Studio.
Each half has an MX style and a Kailh style opener, giving you a total of 2 openers per unit. The two halves are held together by magnets when not in use.
Please keep in mind both e-coating and anodization will wear off from the parts that come in contact with the switch, after repeated use.
-
₹1,250.00 (Inc. GST)
High quality Titanium Switch Pullers from Wuque Studio. Available in four colours!
-
From ₹9.50 to ₹13.00 (Inc. GST)
Make (almost) any PCB hotswappable! These Mill-max 0305 sockets can be soldered in place through holes for most Cherry MX switches, and make (almost) any PCB hotswappable. Perfect if you want to prototype, but aren’t sure which switch is perfect, or if you just want to make your keyboard hotswap. You need 2 sockets for…
End of content
End of content