Filco KeyPuller Keycap Puller
₹360.00 (Inc. GST)The Filco KeyPuller is used to remove keycaps from mechanical and membrane keyboards.
Not meant to be used with laptop or pantograph key mechanisms!
Showing 25–36 of 37 results
The Filco KeyPuller is used to remove keycaps from mechanical and membrane keyboards.
Not meant to be used with laptop or pantograph key mechanisms!
The very best hotswap sockets for hotswap PCB designs, now made even better with increased durability!
All-aluminum switch openers from Wuque Studio.
Each half has an MX style and a Kailh style opener, giving you a total of 2 openers per unit. The two halves are held together by magnets when not in use.
Please keep in mind both e-coating and anodization will wear off from the parts that come in contact with the switch, after repeated use.
High quality Titanium Switch Pullers from Wuque Studio. Available in four colours!
Diodes – General Purpose 100V/150 mA, SOD 123 Footprint
Diodes – General Purpose 100V Io/200mA Height: 1.91 mm Length: 4.56 mm Type: Small Signal Switching Diode Width: 1.91 mm
Capacitance:22pF Voltage(DC):50V Capacitance Tolerance:± 5% Capacitor Terminals:PC Pin Dielectric Characteristic:C0G / NP0 Lead Spacing:2.5mm Capacitor Case / Package:Radial Leaded Product Range:FG Product Diameter:- Product Length:4mm Product Width:2.5mm Product Height:5.5mm Operating Temperature Min:-55°C Operating Temperature Max:125°C
2U Cherry MX plate mount stabilizers.
Make (almost) any PCB hotswappable! These Mill-max 0305 sockets can be soldered in place through holes for most Cherry MX switches, and make (almost) any PCB hotswappable. Perfect if you want to prototype, but aren’t sure which switch is perfect, or if you just want to make your keyboard hotswap. You need 2 sockets for…
A through-hole TRRS jack. The perfect connector for your I2C or SPI needs. Just use a standard 4-pole wire, and use for any communication protocol that runs over up to 4 wires.
Durock Screw-In Stabilisers come pre-clipped nylon housings and gold-plated wires.
Durock Smokey Screw-in Stabilisers are pre-clipped stabilizers made with new molds that prevent wire drop out. The housing and stem are made from Nylon and the wire from gold plated Stainless Steel.
End of content
End of content